Gamma 6004 STRINGING MACHINE 2 POINT SC MOUNTING (Issue Instrukcja Użytkownika Pobierz pdf (Strona 15)

MAINTENANCE & ADJUSTMENTS

Adjusting the Tensioner Brake

After stringing many racquets, the brake

of the tensioner may need to be adjusted.

With the brake lever engaged in the latch,

insert the 5mm hex wrench into the set

screw (A) located at the base of the brake

lever. It can be accessed through the hole

on the face of the tensioner cover (above

the ‘GAMMA’ logo).

Note: The tensioner cover does not need

to be removed for the adjustment. The

cover has been removed in the pictures for

illustration purposes.

To tighten the braking mechanism, turn the

set screw (A) counter clockwise by about 1/8

turn. Re-tighten the bolt (B) on the back side

of the tensioner frame and check for brake

tightness. The tensioner should move freely

along the track with the brake lever engaged

and should hold tension with the brake lever

released. If more adjustment is needed,

repeat steps above until properly adjusted.

While holding the 5mm brake lever adjust-

ment set screw (A), loosen the bolt (B) located

on the back side of the tensioner frame with

the 4 mm hex wrench.

Note: Bolt (B) should only be loosened and

should not be completely removed.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Brak uwag

Gamma 6004 STRINGING MACHINE 2 POINT SC MOUNTING (Issue Instrukcja Użytkownika Strona 15